Seitron Chemist 402 gas analyzer

Description

CHEMIST gas analyzer (Kemist) Seitron
is equipped with a large alphanumeric screen with backlighting, a printing device that works with ordinary paper tape, a single unit of battery charging batteries, pre-calibrated sensors, which can be replaced directly by the user.
The
CHEMIST Seitron
portable combustion gas analyzer
(CHEMIST Seitron) is
designed based on the requirements of technical standards and specific user requests.
Available in a durable plastic ABS case or in a bag on a waterproof fabric belt.
CHEMIST
Seitron
(CEMIST SEITRON) 402 - ASK 625 A
The combustion analyzer Seitron CHEMIST (Seitron CHEMIST) 402
with two sensors (O2 + CO)
,
with the possibility of installing a third cell on NO,
can be equipped with a solenoid valve on request.
Kemist 402 allows direct analysis of O2 and CO, flue gas temperatures, air temperature, pressure in the flue.
Calculated parameters: CO2, air excess factor, efficiency.
You can install the third NO sensor on Kemist 402 at any time, and you will not need to send the device to the service center.
Advantages of a gas analyzer
Kemist
Seytron
(
Chemist
S
eitron)
:
The language of the menu and all information - in Russian or in another (on request).
Buttons with symbols with direct access to the most important functions simplify the use of a gas analyzer.
Using the
Kemist Seytron
gas analyzer
menu, you can set and memorize 5 types of alarms
.
For each type of alarm, you can determine the value of the parameter.
You can set the threshold and type of alarm (alarm on at the minimum or maximum value).
The installation of the alarm system is indicated by an audible or visual alert.
Simultaneously with the alarm triggering, when a certain concentration of CO and NO is reached, it is possible to program the triggering of the solenoid valve, if the device is equipped with one.
Using the menu,
you can enter (or change) the data of the operators (maximum 3), which are authorized to carry out the analysis
, and select the printing order (which operator will be printed first).
Using the menu,
you can enter in the amount of 4 lines of 16 letters in each company name or the name of the owner of the device
and all information relating to it (for example, address, telephone number).
Using the menu, the user can set the method of analysis: manual or automatic.
With manual analysis, the user manually performs the three required analyzes.
With automatic analysis, it is necessary to set the cycle time of each single measurement.
In this case, the gas analyzer will produce each analysis within the prescribed time.